GPSDO GPS Colck 10M LCD Display Frequency Message Disciplined Oscillator USA

Description

Description
GPSDO GPS Colck 10M with LCD Display Frequency Message Disciplined Oscillator
Key Feature:
- Output 10MHz accuracy sine wave or square wave,low noise
- Output 1pps second pulse,sync with UTC time,can keep time.
- High sensitive GPS receive,small sky can lock。
- With lock inductor,red led off,equipment lock.
- Power is 12V/1.5A,simple easy,can used switch power
- Unexpensive,small valume,used convenient
- The unique removal of GPS signal jitter algorithm,higher accuracy
- LCD display GPS strength,time,output frequency
Overview:
GPSDO name GPS disciplined oscillator,used GPS output accuracy time signal to control clock equipment.This equipment used GPS output 1 pps,control on board OCXO,used special algorithm to filter the GPS time jitter.make the OCXO output accuracy clock. always amend.board with LCD display gps strength,time and frequency deviation.
Parameter:
- NAME:LCD-GPS DISCIPLINED OSCILLATOR
- POWER:DC11.7-12.9V<=15W
- GPS ANT POWER:DC3.3V/50mA
- 1PPS OUTPUT:SQUARE WAVE,3.3Vpp
- 10M OUTPUT :SINE WAVE,1Vrms (10-15dBm),square wave,3.3/4.7Vpp
- RS232 OUTPUT:GPS NMEA SIGNAL
- ACCURACY: above than OCXO 2 order of magnitude
- SIZE:W*H*D=107*55*172mm(INCLUDE BNC CONNECT)
1.Work state led
ALM : warning,on,output frequency accuracy is low.
GPS LOCK:GPS lock inductor,while GPS lock,led on.
RUN: run indicator led,led flash,equipment is normal,If not flash,fault in equipment.
2.DB9 connect,output NMEA GPS flow.output 1PPS signal,RS232 level.
3.One pulse per second,BNC connected.from GPS module.rising edge is valid,
4.10MHz output,BNC connected,output sine wave or square wave.
5.Connect active GPS antenna,SMA connected.
6.External power connect,used 5.5mm/2.1mm DC plus.inside is positive,outside is negative,11.7-12.9V max 15W
6.Accessory is 5m active GPS antenna,DC12V/1.5A adapter.connect GPS antenna,connect DC12V power supply.can output 10MHz standard frequency.
ATTENTION:
must be used 5.5/2.1 DC plus,if used 5.5/2.5 will poor contact.
Front is a LCD,display machine state.
4.3 Connect PC
GPSDO-DB9        PC-DB9
PIN2--------------------PIN2
PIN3--------------------PIN3
PIN5--------------------PIN5
PIN8--------------------PIN8
GPSDO-DB9 PIN2,PIN5,PIN8 is connect to PC-DB9 PIN2,PIN5,PIN8,
Baud rate is  9600BPS,Baud rate is fixed.
4.4 Rear panel work state:
Power up : three led all on,all off,then RUN flash,GPS LOCK led off,WARN led on.
Power up current: less than 1.5 A.
Preheat: on board there is a OCXO,OCXO preheat need 30 minute.After a period of time,the current will slowly become small.Until GPS LOCK led on,WARN led off,means the equipment is normal
Normal: RUN led flash,GPS LOCK led on.WARN led off,means GPSDO running normal.When WARN led off,the accuracy is less than 0.05Hz@10MHz,keep GPS lock for 5 hours,the accuracy is less than 0.005Hz@10MHz.
4.5 Front panel LCD state:
Used 1602 LCD, display area there is two line,every line there is 16 character.
GPS signal strength display,First line 1,2 character,display GPS signal strength,first character is antenna mark,all display,second character is GPS signal strength,there is 6 step.from strength weak to strong is empty,1dot,2dots,2+3dots,2+3+4dots,2+3+4+5dots.
Character display area,6character,can via command to setting.
time display area, 8 characters,can via command setting
Disciplined state display,1 character,when system is accuary,display L,else not display.
Referenec output frequency display area,15 character.
Power up,LCD dots all on,then all off,check lcd is good or bad.
then display
GPSDO UTC +/- XX:XX display UTC offset
BG7TBL V20171210 display author and version
complete,enter normal display mode
If GPS not fix,LCD bottom will display GPS NO FIX
4.6 Display mode setting command
Setting display frequency mode,6 character,UTC offset,need short inside PCB jump.
Baud rate is 9600BPS,data bit 8,stop bit 1,Check bit NONE,flow control NONE.
Command is star with $GPGTC,end with T*,middle is 12 byte command.
$GPGTC,X1  X2 X3 X4 X5 X6 X7 X8 X9 X10  X11 X12  T*
X1,setting display frequency mode,10000000.0000Hz,1,10M +/-0.0000Hz,2,10M +/-000.00ppb 3,10M +/-0.00000ppm
X2 X3 X4 X5 X6 X7 display 6 character.
X8 time offset,+/-
X9 X10 hour offset,max 23
X11 X12 minute offset,max 59
Example 1:display BJT,UTC+8,ppb,command is $GPGTC,2  BJT +0800T*
Example 2:display GMT UTC+0,display 10000000.0000Hz,command is $GPGTC,0, GMT +0000T*
Example 3,display EST-5,PPM,command is $GPGTC,3  EST +05:00T*
Command is OK,machine return OK.
connect db9,connect jumper.
com port setting,input command
4.7 Use notes:
LCD display frequency is reference only,there is deviation with actual output.
Gpsdo long time on line,the surface of the machine is warn, This kind of phenomenon is normal.
GPS antenna avoid interference,avoid high voltage,avoid lighting.put antenna to open sky.one line sky can lock,but the accuracy and jitter is worse.
Signal flow:
1575M signal come from GPS antenna,input the GPS module,GPS output 1PPS and NMEA GPS lock signal.Used 1PPS for gate via CPLD and MCU output EFC signal,correct the OCXO output frequency.
FAQ:
1.Q : how can I know the machine is good.
A : power on times,red led off,machine is good.
2. Q : how can I know MCU is good.
A : when power on,all LED will on,then RUN led flash,red LED on,means MCU is good.
3. Q:5m GPS active antenna is short,how to do.can not connect GPS antenna?
A : Used GPS extended line,such as 5m,10m,15m,20m extended line.can not used GPS antenna,it is a OCXO.
4. Q: i used frequency counter test frequency is difference with LCD display frequency,what can i do?
A:LCD display frequency is reference only,actual test there is deviation.when LCD display L10000000.000xHz or other L frequency,frequency is accuary.Make sure test frequency standard is less than 0.001Hz accuary else is the frequency standard deviation.
Q: GPS strength is change some time is high some time is low
A:that is right,Because the signal intensity is affected by the satellite position,the weather and the Algorithm.
Package List:
- 1 x GPS disciplined clock
- 1 x AC110-220-DC12V ADAPTER
- 1 x 5 m GPS ANT
Bezahlung
1.We accept PayPal only.
2.All major credit cards are accepted through secure payment processor PayPal.
3.Payment must be received within 7 business days of auction closing.
4.If you have bought multiple items from me, you can send me one payment for all the items instead of paying for them individually. When you click the Pay Now button, eBay will automatically determine if there are other items you have won or purchased from me and will combine them for your review.
5.
NOTE:
Import duties, taxes and chargers are not included in the item price or shipping charges. These charges are the buyer's responsibility.
Please check with your country's customs office to determine what these additional costs will be prior to bidding buying.
Garantie
1.12 months Warranty. Buy with confidence!
2.If you are not satisfied when you receive your item, please return it within 14 days for a replacement or money back. Please contact me before you return it.
3.If item is defective in 3 months, We will send you a replacement without extra charger, or offer refund after we receive the defective item.
4.If item is defective after 3 months, you can still send it back to us. We will send you a new one after receiving the defective item. But you have to pay the extra shipping fee.
Politik
1.We are not responsible for any custom duty or import tax.
2.We will leave POSITIVE FEEDBACK after receiving the payment. Please contact us if you are not satisfied with the item after receive it.
3.All messages will be answered within 1 business day. If you do not receive our reply, please kindly re-sent your message and we will reply to you as soon as possible.
4.Serious Buyer Only! Please place bid only if you agree with all the terms.
5.If you have any problems or concerns whatever with your order or products, please message us and give us a chance to assist you before you leave any feedback.
We believe we can produce a positive outcome to any situation and will work hard to earn your praise.
If you were pleased with this transaction, Please give us 5 star rating, thanks!!
Lieferung
1.We Ship to Worldwide.
2.Items will be shipped within 1 business day on payment received.
3.Item are shipped from shenzhen using Airmail, reach most of the countries within 10 to 20.
4.Delivery time depends on destination and other factors, it may takes up to 20 business days.
Contact Us
Our office hours are 9:00 a.m to 6:00 p.m (GMT +8) of Monday to Saturday.
And our Office is closed on Sunday and public holidays.
We apologize for the late reply during the holidays.