AC 110V 16A Motor Forward Reverse Controller Motor Speed Controller Motor Dri...

Description

Welcome to our stores!
We guarantee you will be satisfied.
AC 110V 16A Motor Forward Reverse Controller Motor Speed Controller Motor Dri...
Product Overview
Specifications: Input Voltage:AC 85V-250V Signal Mode:low level is active,the width should reach 10ms.The signal terminals are isolated from the 220V output. Adapt to the Motor:bidirectional motor (3-wire or 4-wire) Output Power:300W (the maximum current can reach 16A,if it exceeds 300W,please install a heat sink by yourself,so that the temperature of the thyristor is controlled below 105℃) Output Mode:triac Control Mode:switch signal trigger,or low-level signal (can be connected to single-chip IO,PLC,sensor,etc.) Work Temperature:-25℃~85℃ Work Humidity:5%~95%RH Size:90*50*28mm Working Description: 1.Self-locking:The signal only needs to be triggered once,and the module self-locking keeps running. 2.When encountering a reverse signal during forward rotation,immediately stop for 0.3 seconds and then enter reverse rotation. 3.The limit signal has priority,and it will stop immediately when the forward limit signal is encountered during forward rotation. 4.When there is a forward rotation limit signal,the forward rotation cannot be started. 5.When it encounters a forward rotation signal during reverse rotation,it will immediately stop for 0.3 seconds and then enter forward rotation. 6.The limit signal is given priority,and it will stop immediately when it encounters the reverse limit signal during reversal. 7.When there is a reverse rotation limit signal,the reverse rotation cannot be started. 8.The forward rotation signal and the reverse rotation signal are valid when the low level,that is,a short-term 0V level,will start. 9.The limit signal is normally open.For example,when the SW1 switch is closed or connected to a low level,forward rotation cannot be started.
Key Features
It is a motor forward and reverse controller.It can control the forward and reverse rotation of the single-phase AC motor,and the signal input can be connected to the sensor/MCU/PLC/switch. The motor drive module supports single-phase bidirectional motor,which can perform forward and reverse rotation.
The controller is equipped with a varistor and has surge and lightning protection. The input and output of the motor controller are equipped with X2 safety capacitors,which can eliminate spark interference and grid interference.
Note:1.The GND,12V+,K1,K2,SW1,SW2 signal sides of this module are low voltage,which can be connected to ordinary sensors,microcontrollers,etc. 2.During installation and use,do not touch the high-voltage components on the board.
Pin Introduction: 1.K1:start forward rotation. 2.K2:start reversal. 3.SW1:stop forward rotation. 4.SW2:stop reversing.
SHOP WITH CONFIDENCE: To provide you with the highest quality service, If you have any question, please feel free to contact us.We will provide after-sales service until you are satisfied.
Payment Information
■ Secure payments through eBay.
■ We accept PayPal and all major credit cards.
■ Immediate payment required upon purchase.
■ For any payment issues, please contact our support team.
Shipping Information
■ Orders are shipped to the address provided during checkout. Please verify your address.
■ We process orders within 1 business day (excluding weekends and holidays).
■ Standard delivery time is 3-5 business days.
■ We use trusted carriers like UPS, FedEx, and USPS.
■ Shipping is only available within the contiguous United States. No shipping to Alaska, Hawaii, Puerto Rico, or PO Boxes.
■ If there are any shipping delays, please contact us for support.
Return Policy
■ We offer a 30-day return policy.
■ If you are not satisfied with your purchase, you can return it within 30 days for a full refund.
■ Please contact us to obtain the return address before sending back any items.
■ Items must be returned in their original condition and packaging.